How hard is it to install a remote car start for a 2006 mazda 6 non speed novice-car person?

How hard is it to install a remote car start for a 2006 mazda 6 non speed novice-car person?

bryankrikalo said:

i would like to put a remote start on my car but do not feel like spending 475 at the dealer any suggestions thanks

Posted in Car Audio

2 Responses to “How hard is it to install a remote car start for a 2006 mazda 6 non speed novice-car person?”

pbleek says:

June 1, 2009 at 4:17 am

Spend the money. If you don’t know what you are doing and start cutting ignition wires, with today’s transponder keys and disabler systems. $475 will seem like a bargain. Shop around, you should be able to find a system for $300 installed.

Crash Override says:

June 1, 2009 at 5:08 am

Remote start system aren’t that hard to fit, I have installed them on a few vehicles without problems, as long as you follow the directions carefully you should be fine, pay special attention to the neutral sense wiring, and make sure that the connection to the voltage sense wire is as close to the battery as you can get it and you should be fine. Please remember though that on an ’06 you WILL need an immobilizer bypass module as you will need to hook the bypass module to the sensor ring round the ignition switch.

How hard is it to install a remote car start for a 2006 mazda 6 non speed novice-car person?

2 Responses to “How hard is it to install a remote car start for a 2006 mazda 6 non speed novice-car person?”

Leave a Reply